Control panel/ mini controller

Depending on the type and specification the units are used
to serve the control units ( see control units)
or for autonomous climate control in vehicles, e.g. driver cabines or minibusses.

control panel data sheets (pdf-Datei,72 kB)

read more... : Control panels

Automotive- relays 12V, 24V

The BADER relays are devided in the following functions:
1. time relays with different time responses,  like
    impuls extension, switch- off delay, switch- on delay
2. voltage control relays, for monitoring the on board voltage for switched loads
3. Starter safeguard lock relays, for locking the start operation of running machines

read more... : Automotive relays

CAN- Bus- Systems

The CAN-Bus is a type of network, which is used mainly in the automotive engineering
It combines different control units, called nodes, to exchange informations.
The nodes are installed in the near of the sensors and actors.
The BADER air conditioning systems are build according to this principle.

The following systems serve komplex air conditioning tasks in one- deck and double- deck buses
Concerning the design and implemented software these are customer specified solutions.
They vary depending of the aggregates to be controlled and the "climatisation-philosophy" for
the different types of buses.
With these systems BADER delievers inportant manufacturers like MAN, Neoplan, Viseon.

read more... : CAN systems

Voltage converter

The voltage converter are for converting a 24V an bord voltage to a 230V AC signal.
They vary in different output powers.
The outputs are protected against overload and short cut.

voltage converter data sheets (pdf- Datei, 262 kB)

read more... : Voltage converter

Motor controller

The BADER motor controllers are devided in
- blower controllers
- flap controllers.

The blower controllers changes the speed of a DC motor in dependence of a potentiometer value
or a atteched control voltage.
The flap controllers changes  the angle of a servomotor in dependence of a potentiometer value
or a atteched control voltage.

motor controller data sheets (pdf-Datei, 204 kB)

read more... : Motor controller

Control units

The devices can be used in different modes.
- "stand alone", here all values are preseted, no handling required
- in combination with a control panel,  the communications works by RS232
- or with external switches and potentiometers,  e.g. a control console.

The essential difference between the units is the number of inputs/ outputs.
With modification of the software it is possible to realize different customer requirements.

Control- units-data sheets (pdf-Datei, 344 kB)

read more... : Control units

Thermostats

Electronic two-level controller for for controlling of heating and cooling in climate control units
and vehicles. Relays-output with 1 potential-free 2- way contact.

Electronic three-level controller for for controlling of heating and cooling in climate control units
and vehicles. Relays-output with 2 potential-free 2- way contact.

Electronic three-level controller for controlling of heating and cooling in climate control unit
and vehicles. Relays-output with 2 potential-free 2- way contact.
The difference to the TR-280 is a additionally analog output for controlling blower moduls.

Electronic four-level controller for controlling of heating and cooling in climate control units
iand vehicles. Relays output with 3 potential-free 2- way contact.

Electronic two-level controller for for controlling of heating and cooling in climate control units
and vehicles. Relays-output with 1 potential-free 2- way contact.

Thermostat data sheet (pdf-Datei, 625 kB)

read more... : Thermostats

Temperature sensors

the BADER temperature sensors have different constructions depending of the application
- indoor temperature, roof channel temperature,
  convector temperature, blow out temperature.
- outdoor temperature, motor temperature,  evaporator temperatur.

Sensor-datasheets (pdf- Datei, 297 kB)

read more... : Sensors